From 703418de01a550fe59c7cbe7ae73815947c35021 Mon Sep 17 00:00:00 2001
From: Kevin O'Connor <kevin@koconnor.net>
Date: Thu, 3 Jun 2021 14:07:56 -0400
Subject: [PATCH] docs: Update G-Codes.md now that SET_VELOCITY_LIMIT can
 exceed config

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
---
 docs/G-Codes.md | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/docs/G-Codes.md b/docs/G-Codes.md
index 38e7e389..a885aef1 100644
--- a/docs/G-Codes.md
+++ b/docs/G-Codes.md
@@ -161,8 +161,7 @@ The following standard commands are supported:
   MINIMUM and/or at or below the supplied MAXIMUM.
 - `SET_VELOCITY_LIMIT [VELOCITY=<value>] [ACCEL=<value>]
   [ACCEL_TO_DECEL=<value>] [SQUARE_CORNER_VELOCITY=<value>]`: Modify
-  the printer's velocity limits. Note that one may only set values
-  less than or equal to the limits specified in the config file.
+  the printer's velocity limits.
 - `SET_HEATER_TEMPERATURE HEATER=<heater_name> [TARGET=<target_temperature>]`:
   Sets the target temperature for a heater. If a target temperature is
   not supplied, the target is 0.