config: Remove filament specific settings from printer-geeetech-301.cfg

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2022-11-11 14:09:48 -05:00
parent 0233dd32cc
commit 6be0ba78ae
1 changed files with 5 additions and 9 deletions

View File

@ -1,8 +1,8 @@
# This file contains common pin mappings for the GTM32 PRO board in the Geeetech 301 printer
# To use this config, the firmware should be compiled for the
# STM32F103 with "No bootloader", serial (on USART1 PA10/PA9)
# communication and GPIO pins to set at micro-controller startup set to
# "!PB4,!PB5,!PB0,!PB1"
# This file contains common pin mappings for the GTM32 PRO board in
# the Geeetech 301 printer. To use this config, the firmware should be
# compiled for the STM32F103 with "No bootloader", serial (on USART1
# PA10/PA9) communication and GPIO pins to set at micro-controller
# startup set to "!PB4,!PB5,!PB0,!PB1"
# The "make flash" command does not work on the Geeetech 301. Instead,
# after running "make", run the following command to flash the board:
@ -59,10 +59,6 @@ microsteps: 16
rotation_distance: 32
nozzle_diameter: 0.4
filament_diameter: 1.75
pressure_advance: 0.15
max_extrude_cross_section: 0.5
max_extrude_only_velocity: 30
max_extrude_only_accel: 500
heater_pin: multi_pin:heater
sensor_type: EPCOS 100K B57560G104F
pullup_resistor: 4700