docs: Improve bltouch v3 documentation
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
parent
7702cc2972
commit
500f37821d
|
@ -66,8 +66,8 @@
|
|||
#pin_up_touch_mode_reports_triggered: True
|
||||
# Set if the BLTouch consistently reports a "triggered" state after
|
||||
# the commands "pin_up" followed by "touch_mode". This should be
|
||||
# True for a genuine BLTouch; some BLTouch clones may require
|
||||
# False. The default is True.
|
||||
# True for a genuine BLTouch v2 and earlier; the BLTouch v3 and some
|
||||
# BLTouch clones require False. The default is True.
|
||||
#x_offset:
|
||||
#y_offset:
|
||||
#z_offset:
|
||||
|
|
|
@ -108,3 +108,27 @@ position. Carefully readjust the headless screw into place. You need
|
|||
to find the right position so it is able to lower and raise the pin
|
||||
and the red light turns on and of. Use the `reset`, `pin_up` and
|
||||
`pin_down` commands to achieve this.
|
||||
|
||||
Troubleshooting
|
||||
===============
|
||||
|
||||
* If you are sure the wiring of the BL-Touch is correct and every
|
||||
attempt to probe with the BL-Touch reports "BLTouch failed to verify
|
||||
sensor state" then it may be necessary to add
|
||||
`pin_up_touch_mode_reports_triggered: False` to the bltouch config
|
||||
section. The BL-Touch v3 and many clones require this setting.
|
||||
|
||||
* A BL-Touch v3 may not work correctly when its signal wire is
|
||||
connected to the Z end-stop pin on some printer boards. The symptoms
|
||||
of this problem are: the BL-Touch probe deploys, the printer
|
||||
descends, the probe contacts a surface, the BL-Touch raises the
|
||||
probe, the BL-Touch does not successfully notify the
|
||||
micro-controller, and the printer continues to descend. The Z
|
||||
end-stop pin on some printer boards have a capacitor to filter the
|
||||
signal which the BL-Touch v3 may not support. The simplest solution
|
||||
is to connect the BL-Touch v3 sensor wire to an available pin on the
|
||||
printer board that is not associated with an end-stop (and thus is
|
||||
unlikely to have a capacitor). An alternative solution is to
|
||||
physically alter the printer board to disable the given end-stop
|
||||
capacitor or to add a hardware "pull up resistor" to the BL-Touch v3
|
||||
sensor wire.
|
||||
|
|
Loading…
Reference in New Issue