From 4748dffd7a0fcf736b270b6d37c5e6fbb8f07805 Mon Sep 17 00:00:00 2001
From: Scott Mudge <19617165+scottmudge@users.noreply.github.com>
Date: Sat, 15 Apr 2023 19:17:54 -0400
Subject: [PATCH] docs: Add AHT10 temperature sensor doc section in
 Config_Reference.md (followup #6138) (#6167)

Followed general outline used by HTU21D and BME280.

Signed-off-by: Scott Mudge <mail@scottmudge.com>
---
 docs/Config_Reference.md | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md
index 7aab31d7..eda1a06e 100644
--- a/docs/Config_Reference.md
+++ b/docs/Config_Reference.md
@@ -2375,6 +2375,29 @@ sensor_type: BME280
 #   above parameters.
 ```
 
+### AHT10 temperature sensor
+
+AHT10 two wire interface (I2C) environmental sensor.
+Note that these sensors are not intended for use with extruders and
+heater beds, but rather for monitoring ambient temperature (C) and
+relative humidity. See
+[sample-macros.cfg](../config/sample-macros.cfg) for a gcode_macro
+that may be used to report humidity in addition to temperature.
+
+```
+sensor_type: AHT10
+#i2c_address:
+#   Default is 56 (0x38). Some AHT10 sensors give the option to use
+#   57 (0x39) by moving a resistor.
+#i2c_mcu:
+#i2c_bus:
+#i2c_speed:
+#   See the "common I2C settings" section for a description of the
+#   above parameters.
+#aht10_report_time:
+#   Interval in seconds between readings. Default is 30, minimum is 5
+```
+
 ### HTU21D sensor
 
 HTU21D family two wire interface (I2C) environmental sensor. Note that