diff --git a/docs/Config_Changes.md b/docs/Config_Changes.md
index 3aeedb0e..0236fbd6 100644
--- a/docs/Config_Changes.md
+++ b/docs/Config_Changes.md
@@ -6,6 +6,9 @@ All dates in this document are approximate.
 
 # Changes
 
+20210310: The TMC2660 default for driver_SFILT has been changed from 1
+to 0.
+
 20210227: TMC stepper motor drivers in UART or SPI mode are now
 queried once per second whenever they are enabled - if the driver can
 not be contacted or if the driver reports an error, then Klipper will
diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md
index 28d22945..8ebb511c 100644
--- a/docs/Config_Reference.md
+++ b/docs/Config_Reference.md
@@ -2817,7 +2817,7 @@ run_current:
 #driver_SEMAX: 0
 #driver_SEUP: 0
 #driver_SEMIN: 0
-#driver_SFILT: 1
+#driver_SFILT: 0
 #driver_SGT: 0
 #driver_SLPH: 0
 #driver_SLPL: 0
diff --git a/klippy/extras/tmc2660.py b/klippy/extras/tmc2660.py
index 8790ddbe..9d68adf3 100644
--- a/klippy/extras/tmc2660.py
+++ b/klippy/extras/tmc2660.py
@@ -100,7 +100,6 @@ FieldFormatters = dict(tmc2130.FieldFormatters)
 FieldFormatters.update({
     "DEDGE": (lambda v: "1(Both Edges Active!)" if v else ""),
     "CHM": (lambda v: "1(constant toff)" if v else "0(spreadCycle)"),
-    "SFILT": (lambda v: "1(Filtered mode)" if v else "0(Standard mode)"),
     "VSENSE": (lambda v: "%d(%dmV)" % (v, 165 if v else 305)),
     "SDOFF": (lambda v: "1(Step/Dir disabled!)" if v else ""),
     "DISS2G": (lambda v: "%d(Short to GND disabled!)" if v else ""),
@@ -256,7 +255,7 @@ class TMC2660:
         set_config_field(config, "SEMIN", 0)
 
         # SGSCONF
-        set_config_field(config, "SFILT", 1)
+        set_config_field(config, "SFILT", 0)
         set_config_field(config, "SGT", 0)
 
         # DRVCONF