docs: Recommend normal slicer settings in Pressure_Advance.md

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2019-11-25 11:34:03 -05:00
parent 3683273936
commit 3aad25eab9
1 changed files with 10 additions and 1 deletions

View File

@ -97,6 +97,15 @@ Important Notes
[nozzle temperature](http://reprap.org/wiki/Triffid_Hunter%27s_Calibration_Guide#Nozzle_Temperature)
prior to tuning pressure advance.
* The test print is designed to run with a high extruder flow rate,
but otherwise "normal" slicer settings. A high flow rate is obtained
by using a high printing speed (eg, 100mm/s) and a coarse layer
height (typically around 75% of the nozzle diameter). Other slicer
settings should be similar to their defaults (eg, perimeters of 2 or
3 layers, normal retraction amount). It can be useful to set the
external perimeter speed to be the same speed as the rest of the
print, but it is not a requirement.
* It is common for the test print to show different behavior on each
corner. Often the slicer will arrange to change layers at one corner
which can result in that corner being significantly different from