diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md
index 812dd7a9..e3c6bfbb 100644
--- a/docs/Config_Reference.md
+++ b/docs/Config_Reference.md
@@ -1319,8 +1319,9 @@ a belt printer, can find use in looping sections of the sdcard file.
 (For example, to print the same part over and over, or repeat the
 a section of a part for a chain or other repeated pattern).
 
-See the `config/sample-macros.cfg` file for a Marlin compatible M808
-G-Code macro.
+See the [command reference](G-Codes.md#sdcard-loop) for supported
+commands. See the [sample-macros.cfg](../config/sample-macros.cfg)
+file for a Marlin compatible M808 G-Code macro.
 
 ```
 [sdcard_loop]
diff --git a/docs/G-Codes.md b/docs/G-Codes.md
index cb84fa65..273870d5 100644
--- a/docs/G-Codes.md
+++ b/docs/G-Codes.md
@@ -66,13 +66,6 @@ In addition, the following extended commands are availble when the
 - Load a file and start SD print: `SDCARD_PRINT_FILE FILENAME=<filename>`
 - Unload file and clear SD state: `SDCARD_RESET_FILE`
 
-When the [sdcard_loop config section](Config_Reference.md#sdcard_loop) is
-enabled, the following extended commands are available.
-- Begin a looped section in the SD print: `SDCARD_LOOP_BEGIN COUNT=<count>`
-  - A count of 0 indicates that the section should be looped indefinately.
-- End a looped section in the SD print: `SDCARD_LOOP_END`
-- Complete existing loops without further iterations: `SDCARD_LOOP_DESIST`
-
 ## G-Code arcs
 
 The following standard G-Code commands are available if a
@@ -541,6 +534,17 @@ enabled:
   future boundary checks; issue a G28 afterwards to reset the
   kinematics.
 
+## SDcard loop
+
+When the [sdcard_loop config section](Config_Reference.md#sdcard_loop)
+is enabled, the following extended commands are available:
+- `SDCARD_LOOP_BEGIN COUNT=<count>`: Begin a looped section in the SD
+  print. A count of 0 indicates that the section should be looped
+  indefinately.
+- `SDCARD_LOOP_END`: End a looped section in the SD print.
+- `SDCARD_LOOP_DESIST`: Complete existing loops without further
+  iterations.
+
 ## Send message (respond) to host
 
 The following commands are availabe when the