3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

config: Comment updates for recent "make menuconfig" updates 

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2021-03-29 20:00:26 -04:00
parent 00706dec21
commit 34bf8a04c7
2 changed files with 4 additions and 5 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

4
config/generic-fysetc-cheetah-v1.2.cfg
View File

@ -1,7 +1,7 @@
# This file contains common pin mappings for the Fysetc Cheetah v1.2b # This file contains common pin mappings for the Fysetc Cheetah v1.2b
# board. To use this config, the firmware should be compiled for the # board. To use this config, the firmware should be compiled for the
# STM32F103 with "No bootloader" and with "Use USB for communication" # STM32F103 with "No bootloader" and serial (on USART1 PA10/PA9)
# disabled. # communication.
# The "make flash" command does not work on the Cheetah. Instead, # The "make flash" command does not work on the Cheetah. Instead,
# after running "make", run the following command to flash the board: # after running "make", run the following command to flash the board:

5
config/printer-twotrees-sapphire-pro-2020.cfg
View File

@ -2,9 +2,8 @@
# Pro printer from 2020. To use this config, the firmware should be # Pro printer from 2020. To use this config, the firmware should be
# compiled for the STM32F103. When running "make menuconfig", enable # compiled for the STM32F103. When running "make menuconfig", enable
# "extra low-level configuration setup", select the 28KiB bootloader, # "extra low-level configuration setup", select the 28KiB bootloader,
# disable "USB for communication", select USART3 for the "Serial # serial (on USART3 PB11/PB10) communication, and set "GPIO pins to
# Port", and set "GPIO pins to set at micro-controller startup" to # set at micro-controller startup" to "!PC6,!PD13".
# "!PC6,!PD13".
# Note that the "make flash" command does not work with the Sapphire # Note that the "make flash" command does not work with the Sapphire
# Pro. After running "make", run the following command: # Pro. After running "make", run the following command: