diff --git a/klippy/extras/display/menu.cfg b/klippy/extras/display/menu.cfg
index d3d99d68..b0df9fc5 100644
--- a/klippy/extras/display/menu.cfg
+++ b/klippy/extras/display/menu.cfg
@@ -24,6 +24,9 @@
 #       + Home All
 #       + Home Z
 #       + Home X/Y
+#       + Z Tilt
+#       + Quad Gantry Lvl
+#       + Bed Mesh
 #       + Steppers off
 #       + Fan: OFF
 #       + Fan speed: 000%
@@ -233,6 +236,24 @@ enable: {not printer.idle_timeout.state == "Printing"}
 name: Home X/Y
 gcode: G28 X Y
 
+[menu __main __control __z_tilt]
+type: command
+enable: {not printer.idle_timeout.state == "Printing" and ('z_tilt' in printer)}
+name: Z Tilt
+gcode: Z_TILT_ADJUST
+
+[menu __main __control __quad_gantry_level]
+type: command
+enable: {not printer.idle_timeout.state == "Printing" and ('quad_gantry_level' in printer)}
+name: Quad Gantry Lvl
+gcode: QUAD_GANTRY_LEVEL
+
+[menu __main __control __bed_mesh]
+type: command
+enable: {not printer.idle_timeout.state == "Printing" and ('bed_mesh' in printer)}
+name: Bed Mesh
+gcode: BED_MESH_CALIBRATE
+
 [menu __main __control __disable]
 type: command
 name: Steppers off
@@ -683,7 +704,7 @@ name: Calibration
 
 [menu __main __setup __calib __delta_calib_auto]
 type: command
-enable: {not printer.idle_timeout.state == "Printing"}
+enable: {(not printer.idle_timeout.state == "Printing") and ('delta_calibrate' in printer)}
 name: Delta cal. auto
 gcode:
     G28
@@ -691,12 +712,12 @@ gcode:
 
 [menu __main __setup __calib __delta_calib_man]
 type: list
-enable: {not printer.idle_timeout.state == "Printing"}
+enable: {(not printer.idle_timeout.state == "Printing") and ('delta_calibrate' in printer)}
 name: Delta cal. man
 
 [menu __main __setup __calib __bedprobe]
 type: command
-enable: {not printer.idle_timeout.state == "Printing"}
+enable: {(not printer.idle_timeout.state == "Printing") and ('probe' in printer)}
 name: Bed probe
 gcode: PROBE