From 29b5961d9f6b3a24e73ed4d52233f463f8670619 Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Thu, 7 Nov 2019 15:39:51 -0500 Subject: [PATCH] docs: Note gcode_arcs and firmware_retraction commands in G-Codes.md Signed-off-by: Kevin O'Connor --- docs/G-Codes.md | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-) diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 66906f70..b01d6487 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -43,8 +43,8 @@ possible G-Code command. Instead, Klipper prefers human readable If one requires a less common G-Code command then it may be possible to implement it with a custom Klipper gcode_macro (see [example-extras.cfg](https://github.com/KevinOConnor/klipper/tree/master/config/example-extras.cfg) -for details). For example, one might use this to implement: `G10`, -`G11`, `G12`, `G29`, `G30`, `G31`, `M42`, `M80`, `M81`, etc. +for details). For example, one might use this to implement: `G12`, +`G29`, `G30`, `G31`, `M42`, `M80`, `M81`, etc. ## G-Code SD card commands @@ -58,6 +58,20 @@ Klipper also supports the following standard G-Code commands if the - Set SD position: `M26 S` - Report SD print status: `M27` +## G-Code arcs + +The following standard G-Code commands are available if a "gcode_arcs" +config section is enabled: +- Controlled Arc Move (G2 or G3): `G2 [X] [Y] [Z] + [E] [F] I J` + +## G-Code firmware retraction + +The following standard G-Code commands are available if a +"firmware_retraction" config section is enabled: +- Retract: `G10` +- Unretract: `G11` + ## G-Code display commands The following standard G-Code commands are available if a "display"