3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

docs: Move SET_TEMPERATURE_FAN_TARGET to its own section in G-Codes.md 

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2020-07-26 10:41:43 -04:00
parent ab923883f7
commit 25a9a32ecb
1 changed files with 9 additions and 2 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

11
docs/G-Codes.md
View File

@ -210,8 +210,6 @@ The following standard commands are supported:
defaults to "display" (the primary display).
- `SET_IDLE_TIMEOUT [TIMEOUT=<timeout>]`: Allows the user to set the
idle timeout (in seconds).
- `SET_TEMPERATURE_FAN_TARGET temperature_fan=<temperature_fan_name> [target=<target_temperature>]`:
Sets the target temperature for a temperature_fan. If a target is not supplied, it is set to the specified temperature in the config file.
- `RESTART`: This will cause the host software to reload its config
and perform an internal reset. This command will not clear error
state from the micro-controller (see FIRMWARE_RESTART) nor will it
@ -614,3 +612,12 @@ been enabled:
of SHAPER_TYPE_X and SHAPER_TYPE_Y parameters. See
[example-extras.cfg](https://github.com/KevinOConnor/klipper/tree/master/config/example-extras.cfg)
for more details on each of these parameters.
## Temperature Fan Commands
The following command is available when a "temperature_fan" config
section is enabled:
- `SET_TEMPERATURE_FAN_TARGET temperature_fan=<temperature_fan_name>
[target=<target_temperature>]`: Sets the target temperature for a
temperature_fan. If a target is not supplied, it is set to the
specified temperature in the config file.