From 25a9a32ecb03130ad6bc9282c8d126f9b1ae57a1 Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Sun, 26 Jul 2020 10:41:43 -0400 Subject: [PATCH] docs: Move SET_TEMPERATURE_FAN_TARGET to its own section in G-Codes.md Signed-off-by: Kevin O'Connor --- docs/G-Codes.md | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-) diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 5b5c0374..96f28173 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -210,8 +210,6 @@ The following standard commands are supported: defaults to "display" (the primary display). - `SET_IDLE_TIMEOUT [TIMEOUT=]`: Allows the user to set the idle timeout (in seconds). -- `SET_TEMPERATURE_FAN_TARGET temperature_fan= [target=]`: - Sets the target temperature for a temperature_fan. If a target is not supplied, it is set to the specified temperature in the config file. - `RESTART`: This will cause the host software to reload its config and perform an internal reset. This command will not clear error state from the micro-controller (see FIRMWARE_RESTART) nor will it @@ -614,3 +612,12 @@ been enabled: of SHAPER_TYPE_X and SHAPER_TYPE_Y parameters. See [example-extras.cfg](https://github.com/KevinOConnor/klipper/tree/master/config/example-extras.cfg) for more details on each of these parameters. + +## Temperature Fan Commands + +The following command is available when a "temperature_fan" config +section is enabled: +- `SET_TEMPERATURE_FAN_TARGET temperature_fan= + [target=]`: Sets the target temperature for a + temperature_fan. If a target is not supplied, it is set to the + specified temperature in the config file.