diff --git a/config/example-extras.cfg b/config/example-extras.cfg
index 459a61aa..24e0278a 100644
--- a/config/example-extras.cfg
+++ b/config/example-extras.cfg
@@ -59,11 +59,11 @@
 # g-code command that may be used to calibrate appropriate x and y
 # adjustment parameters.
 #points:
-#    A list of X,Y coordinates (one per line; subsequent lines
-#    indented) that should be probed during a BED_TILT_CALIBRATE
-#    command. Specify coordinates of the nozzle and be sure the probe
-#    is above the bed at the given nozzle coordinates. The default is
-#    to not enable the command.
+#   A list of X,Y coordinates (one per line; subsequent lines
+#   indented) that should be probed during a BED_TILT_CALIBRATE
+#   command. Specify coordinates of the nozzle and be sure the probe
+#   is above the bed at the given nozzle coordinates. The default is
+#   to not enable the command.
 #speed: 50
 #   The speed (in mm/s) of non-probing moves during the
 #   calibration. The default is 50.
@@ -147,16 +147,16 @@
 # extended G-Code command becomes available.
 #[z_tilt]
 #z_positions:
-#    A list of X,Y coordinates (one per line; subsequent lines
-#    indented) describing the location of each Z stepper. The first
-#    entry corresponds to stepper_z, the second to stepper_z1, the
-#    third to stepper_z2, etc. This parameter must be provided.
+#   A list of X,Y coordinates (one per line; subsequent lines
+#   indented) describing the location of each Z stepper. The first
+#   entry corresponds to stepper_z, the second to stepper_z1, the
+#   third to stepper_z2, etc. This parameter must be provided.
 #points:
-#    A list of X,Y coordinates (one per line; subsequent lines
-#    indented) that should be probed during a Z_TILT_ADJUST
-#    command. Specify coordinates of the nozzle and be sure the probe
-#    is above the bed at the given nozzle coordinates. This parameter
-#    must be provided.
+#   A list of X,Y coordinates (one per line; subsequent lines
+#   indented) that should be probed during a Z_TILT_ADJUST command.
+#   Specify coordinates of the nozzle and be sure the probe is above
+#   the bed at the given nozzle coordinates. This parameter must be
+#   provided.
 #speed: 50
 #   The speed (in mm/s) of non-probing moves during the calibration.
 #   The default is 50.