3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

docs: Make it clear a RESTART is likely needed in Installation document 

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2017-05-03 11:14:23 -04:00
parent 98f2adbcb5
commit 02549c9299
1 changed files with 9 additions and 8 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

17
docs/Installation.md
View File

@ -101,14 +101,15 @@ click "Connect". (If "/tmp/printer" is not an available selection then
try reloading the page.)
Once connected, navigate to the "Terminal" tab and type "status"
(without the quotes) into the command entry box and click "Send". If
the Klipper config file was successfully read, and the
micro-controller was successfully found and configured, then this
command will report that the printer is ready. It is not unusual to
have a configuration error during the initial setup - one may modify
the printer config file and then issue a "restart" command in the
OctoPrint terminal to reload the config. Continue modifying the config
and restarting until "status" reports the printer is ready.
(without the quotes) into the command entry box and click "Send". The
terminal window will likely report there is an error opening the
config file - issue a "restart" command in the OctoPrint terminal to
load the config. A "status" command will report the printer is ready
if the Klipper config file is successfully read and the
micro-controller is successfully found and configured. It is not
unusual to have configuration errors during the initial setup - update
the printer config file and issue "restart" until "status" reports the
printer is ready.
Klipper reports error messages via the OctoPrint terminal tab. The
"status" command can be used to re-report error messages. The default