3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

docs: Make it clear a RESTART is likely needed in Installation document 

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2017-05-03 11:14:23 -04:00
parent 98f2adbcb5
commit 02549c9299
1 changed files with 9 additions and 8 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

17
docs/Installation.md
View File

@ -101,14 +101,15 @@ click "Connect". (If "/tmp/printer" is not an available selection then
try reloading the page.) try reloading the page.)
Once connected, navigate to the "Terminal" tab and type "status" Once connected, navigate to the "Terminal" tab and type "status"
(without the quotes) into the command entry box and click "Send". If (without the quotes) into the command entry box and click "Send". The
the Klipper config file was successfully read, and the terminal window will likely report there is an error opening the
micro-controller was successfully found and configured, then this config file - issue a "restart" command in the OctoPrint terminal to
command will report that the printer is ready. It is not unusual to load the config. A "status" command will report the printer is ready
have a configuration error during the initial setup - one may modify if the Klipper config file is successfully read and the
the printer config file and then issue a "restart" command in the micro-controller is successfully found and configured. It is not
OctoPrint terminal to reload the config. Continue modifying the config unusual to have configuration errors during the initial setup - update
and restarting until "status" reports the printer is ready. the printer config file and issue "restart" until "status" reports the
printer is ready.
Klipper reports error messages via the OctoPrint terminal tab. The Klipper reports error messages via the OctoPrint terminal tab. The
"status" command can be used to re-report error messages. The default "status" command can be used to re-report error messages. The default